|
home | contact us | sitemap |
|
|||||||||
|
FAQ
| Instructions
Instructions for LED kits |
LED LIGHT INSTRUCTIONS
To Install the LED's you might need to bend the metal clips that hold the normal dome lights in place in or out a bit. You can use pliers, or a flat head screwdriver to bend the metal clips.
The best way to install the LED lights is to take out the whole Assembly if able too, otherwise most Interior light asemblies have little indents to place a small flathead screwdriver to pop the cover off.
If the LED does not turn on it means the polarity is wrong(backwards) Flip around the LED light and the light should turn on.
Negatives are labeled with a black mark on the board.
Warning: Be gentle with the LED baords and there clips. DO NOT Bend the clips on the LED board. Doing this will break the board and void a warranty replacement.
Also Be careful not to short out your dome lights. If you do short out the dome lights it will blow the fuse and most likely the LED light. If the light is blown it is up to LEDCreations staff to decide to cover it or not. Blown lights from incorrect install is not covered in warranty.
NOTE: If you notice that the LED board is slightly on without the switch on this is normal. LED's can run with less then one volt and your lighting system may have a slight voltage running through it causing the LED to Slightly turn on. DO NOT worry this will not drain your battery.
All LED's are tested before shipping out and are free of defects. We are not responsible for any problems that might occur due to the usage of the LED lights.
If you have a questions on installing please e-mail us at Questions@LEDCreations.com
