The plug and play Cold Cathode kit is very easy to install. Simply open the trunk
find your trunk light, pop out the light housing with a flat head screwdriver
and remove the old bulb. After removing the old bulb take the connector for the
cold cathode trunk kit and place it into the the slot ment for the filament bulb.
One thing to make sure though is to match the black mark on the back of the
connector board with the resistor side or the Trunk light housing. If not
installed correctly it can cause the inverter to blow, making the trunk light not
work. Please Follow the picture below and if you have any other questions feel
free to contact us. Look at the picture below to understand. The black resistor
on the housing and the black mark on the cathode go together. Black resistor may
vary in color on Trunk light housing.