Very easy just pull from the front
plastice cover towards the back seat and it will pop off.
Then pull out the light bulbs and replace with LED lights.
If the LED lights don't turn on flip them around and try
again.
Rear Lights:
Easy but sometimes can be tricky.
On the O side of the light housing there is a metal tab
that needs to be pushedin to release the housing. A small
flat head screwdriver or I perfer a butter knife works great
to do this.
After Out disconnect the housing
from the harness.
The positive side is on the harness hook up side
Make sure when installing the light
that the black
mark on the light matchs the back side of the
lighthousing
Visor Lights:
To remove the visor lights is the same
way you remove the rear lights. With
the visor lights you'll see a small
tab that indicates where the metal
clip is. Put the flat head screwdriver
in on that side
Flat head screwdriver in side.
Disconnect just like rear light. Remember Black
mark on the light
goes away from the harness hookup
Black mark is on the left side of
Light.
Door Lights:
Doors work the same way as the other
lights. Just be sure to disconnect
the harness.
Be sure to disconnect
Just like the Rear, and visor
lights the black mark goes away
from the harnass plug in.
License Plate Lights:
Simple Unscrew the light housing.
disconnect light housinh.
install LED light. Plug back in.
If light does not turn on flip around
and try again.
Side Turn Lights:
If light does not turn on installed
one way flip around and try again.
